NETGEAR 5200 Replace a Disk

Maintenance

NETGEAR ReadyDATA 5200

Replace a Disk

If a disk fails, your system provides email alerts and status messages about the need to

replace a disk. You do not need to power down your unit when replacing a disk.

To replace a 2.5-inch disk:

1. If a disk failed, scan disk LEDs on the disk bays to identify the failed disk.

2. Pull the disk tray release pull switch.

The tray handle pops out.

1. Disk tray handle

2. Disk tray release pull switch

3. Pull out the disk tray, turn the disk over, remove the screws, and separate the metal plate

and the disk tray.

Contents

Main NETGEAR ReadyDATA 5200 Support Trademarks Table of Contents Chapter 1 Getting Started Appendix B Notification of Compliance Chapter 2 Expansion Disk Arrays Chapter 3 Maintenance Page Front Panel Page Rear Panel Status and Shutdown Table 1. Status indicators (continued) Boot Menu Page Factory Settings The following table lists factory settings for the ReadyDATA 5200. Table 2. Factory settings Technical Specifications The following table lists the technical specifications for the ReadyDATA 5200. Table 3. ReadyDATA 5200 technical specifications Page Front Panel Page Rear Panel Expansion Disk Arrays NETGEAR ReadyDATA 5200 Status Information Technical Specifications The following table lists the technical specifications for the EDA2000. Table 4. EDA2000 technical specifications Expansion Disk Arrays The following table lists the technical specifications for the EDA4000. Table 5. EDA4000 technical specifications Page Front Bezel Page Disks Failed Disk Notification Add a Disk Page Page Page Replace a Disk Page Page System Components Power Supply System Interior Fan Battery A Safety Warnings Electrical Safety Precautions General Safety Precautions Electrostatic Discharge (ESD) Precautions B