NETGEAR 5200 - page 28

Maintenance

NETGEAR ReadyDATA 5200

4. Remove the screws that hold the disk drive to the metal tabs and remove the old disk drive.

5. Replace the disk drive and reassemble the disk tray.

For more information, see Add a Disk on page 23.

6. Slide the disk tray back into the unit and secure the handle.

Contents

Main NETGEAR ReadyDATA 5200 Support Trademarks Table of Contents Chapter 1 Getting Started Appendix B Notification of Compliance Chapter 2 Expansion Disk Arrays Chapter 3 Maintenance Page Front Panel Page Rear Panel Status and Shutdown Table 1. Status indicators (continued) Boot Menu Page Factory Settings The following table lists factory settings for the ReadyDATA 5200. Table 2. Factory settings Technical Specifications The following table lists the technical specifications for the ReadyDATA 5200. Table 3. ReadyDATA 5200 technical specifications Page Front Panel Page Rear Panel Expansion Disk Arrays NETGEAR ReadyDATA 5200 Status Information Technical Specifications The following table lists the technical specifications for the EDA2000. Table 4. EDA2000 technical specifications Expansion Disk Arrays The following table lists the technical specifications for the EDA4000. Table 5. EDA4000 technical specifications Page Front Bezel Page Disks Failed Disk Notification Add a Disk Page Page Page Replace a Disk Page Page System Components Power Supply System Interior Fan Battery A Safety Warnings Electrical Safety Precautions General Safety Precautions Electrostatic Discharge (ESD) Precautions B