NETGEAR 5200 Battery

Maintenance

NETGEAR ReadyDATA 5200

Battery

Your system uses a CR2032 battery. Dispose of used batteries according to the

manufacturer’s instructions.

DANGER:

Installing the on-board battery upside down, which reverses its

polarities, creates a danger of explosion. Take care to install the battery

properly.

To replace the battery:

1. Open the system and locate the battery holder.

2. Remove the old battery.

3. Install the new battery.

Take care to install the new battery with the correct side up.

Lithium battery Lithium battery

Battery holder Battery holder

Contents

Main NETGEAR ReadyDATA 5200 Support Trademarks Table of Contents Chapter 1 Getting Started Appendix B Notification of Compliance Chapter 2 Expansion Disk Arrays Chapter 3 Maintenance Page Front Panel Page Rear Panel Status and Shutdown Table 1. Status indicators (continued) Boot Menu Page Factory Settings The following table lists factory settings for the ReadyDATA 5200. Table 2. Factory settings Technical Specifications The following table lists the technical specifications for the ReadyDATA 5200. Table 3. ReadyDATA 5200 technical specifications Page Front Panel Page Rear Panel Expansion Disk Arrays NETGEAR ReadyDATA 5200 Status Information Technical Specifications The following table lists the technical specifications for the EDA2000. Table 4. EDA2000 technical specifications Expansion Disk Arrays The following table lists the technical specifications for the EDA4000. Table 5. EDA4000 technical specifications Page Front Bezel Page Disks Failed Disk Notification Add a Disk Page Page Page Replace a Disk Page Page System Components Power Supply System Interior Fan Battery A Safety Warnings Electrical Safety Precautions General Safety Precautions Electrostatic Discharge (ESD) Precautions B