NETGEAR 7000 manual Quick Start Commands Mode Description

NETGEAR 7000 Series Managed Switch Administration Guide

•Uploading from Networking Device to Out-of-Band PC (Only XMODEM)

•Downloading from Out-of-Band PC to Networking Device (Only XMODEM)

•Downloading from TFTP Server

•Restoring factory defaults

If you configure any network parameters, you should execute the following command: copy system:running-config nvram:startup-config

This command saves the changes to the configuration file. You must be in the correct mode to execute the command. If you do not save the configuration, all changes are lost when a you power down or reset the networking device. In a stacking environment, the running configuration is saved in all units of the stack.

Table 1-1describes the command syntax, the mode you must be in to execute the command, and the purpose and output of the command.

Table 1-1. Quick Start Commands

Command	Mode	Description
show hardware	Privileged	Shows hardware version, MAC address, and software version
	EXEC	information.
show users	Privileged	Displays all of the users that are allowed to access the network-
	EXEC	ing device.
		Access Mode shows whether you can change parameters on the
		networking device (Read/Write) or can only view them (Read
		Only).
		As a factory default, the ‘admin’ user has Read/Write access
		and the ‘guest’ user has Read Only access. There can only be
		one Read/Write user. There can be up to five Read Only users.
show	User EXEC	Displays all of the login session information.
loginsession
users passwd	Global Config	Allows the user to set passwords or change passwords needed
<username>		to login.
		A prompt appears after the command is entered requesting the
		users old password. In the absence of an old password leave the
		area blank.
		User password should not be more than eight characters in
		length.
Getting Started		1-7

v1.1, May 2006