Radiation Pattern: Elevation (Vertical plane)
340 350 | 0 | 10 | 20 |
| |
330 |
|
|
| 30 |
|
320 |
|
|
| 40 |
|
310 |
|
|
| 50 |
|
300 |
|
|
| 60 |
|
290 |
|
|
| 70 |
|
280 |
|
|
| 80 |
|
270 |
|
|
| 90 |
|
260 |
|
|
| 100 |
|
250 |
|
|
| 110 |
|
240 |
|
|
| 120 |
|
230 |
|
|
| 130 |
|
220 |
|
|
| 140 | Brackets |
210 |
|
|
| 150 | |
|
|
|
| ||
200 | 190 | 180 | 170 160 |
| |
Antenna
Front
Top
Side View
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause undesired operation.
In the U.S., the ANT24D18 antenna should only be used with devices that have been FCC approved for use with it. Please check the NETGEAR web site at http://www.NETGEAR.com/go/antannas_fcc for an updated list of FCC approved devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help.
Radiation Pattern: Azimuth (Horizontal plane)
340 350 | 0 | 10 | 20 |
| |
330 |
|
|
| 30 |
|
320 |
|
|
| 40 |
|
310 |
|
|
| 50 |
|
300 |
|
|
| 60 |
|
290 |
|
|
| 70 |
|
280 |
|
|
| 80 |
|
270 |
|
|
| 90 |
|
260 |
|
|
| 100 |
|
250 |
|
|
| 110 | Brackets |
|
|
|
|
| |
240 |
|
|
| 120 |
|
230 |
|
|
| 130 |
|
220 |
|
|
| 140 |
|
210 |
|
|
| 150 |
|
200 | 190 | 180 | 170 160 |
| |
Antenna
Front
Side
Top View
Federal Communications Commission (FCC) and European Radiation Exposure Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 50 cm (20 inches) during normal operation. This device should not be
European Emission Statement
For EU, use of any antenna requires careful planning and extra consideration to comply with EU emissions, health standards and regulations. It is recommended that a qualified professional installer service is consulted for site survey and proper installation. Antenna installation must comply with the maximum level authorized by each country. See http://www.NETGEAR.com/go/antannas_eu for product combinations that comply with EU regulations.
Safety
The NETGEAR wireless devices WG302, FWG114P, FVM318, ME103, and FM114P have been tested with the antenna ANT24D18 and have successfully passed all relevant tests contained in the Standard for the Safety of Information Technology Equipment for Europe (EN
16 | 17 |
