Wall Mount with Adjustable Bracket

 

2 plastic

 

screws

 

bracket B

 

2-screw

 

washer

screw

tube

screw nut

screw

tube

screw nut

 

 

bracket A

washer

Wall Mount with Fixed Bracket

Now, Connect the Antenna

The instructions below cover outdoor and indoor installations.

Connecting the Antenna for an Outdoor Installation

1.Turn off your wireless unit.

2.Connect the provided 2-meter cable to the antenna and to the arrestor as shown here. You can connect the cable to either of the two RF ports on the lightning arrestor.

Wireless unit's

18 dBi Patch Panel

DC block

Directional Antenna

 

 

ANT24D18

 

Wireless unit

N/SMA adapter

 

 

Lightning

2m cable

5-12V DC

ETHERNET

arrestor

 

RESET

 

(provided)

 

NETGEAR cable

 

Ethernet

ACC-10314-01, 02, 03, 04, 05

 

(Sold separately)

 

(CAT 5) cable

 

Ground cable

Building

 

 

(Not provided)

 

grounding

 

 

3.Connect the grounding cable (not included) from the lightning arrestor to the ground of the building.

Grounding cable: The grounding cable must be equivalent or better than: AWG 10, UL 1015, Stranded, 600 V, 105°C, green or green/yellow insulation, 2 clip of 5.5 mm inner diameter cramped at both ends, cable no longer than 5 meters.

Warning: the lightning arrestor and appropriate ground cable must be used for outdoor installation. NETGEAR does not assume any responsibility in case of hazard resulting of non-compliance with these instructions.

4.Screw the N/SMA Reverse Adapter on the lightning arrestor (clockwise) on the second RF port. Connect a NETGEAR cable model ACC-10314-01, 02, 03, 04 or 05 (sold separately) to the adapter.

5.Locate the primary detachable antenna on the wireless access point. Remove the antenna and connect the other end of the NETGEAR cable ACC-10314-01, 02, 03, 04 or 05 to this port.

8

9

Page 6
Image 6
NETGEAR ANT24D18 manual Wall Mount with Adjustable Bracket, Wall Mount with Fixed Bracket