NETGEAR DGN1000-100NAS manual LED Descriptions, Label LED Activity Description

You can use the LEDs to verify various conditions.Table 1 describes each LED.

Table 1.	LED Descriptions
Label		LED Activity	Description
Power		Solid Green	Power is supplied to the router.
		Solid Red	POST (Power-On Self-Test) failure or device malfunction
		Off	Power is not supplied to the router
		Factory reset	Lights momentarily when the reset button is pressed for 6 seconds,
			then blinks red three times when released. It then turns green as the
			gateway resets to the factory defaults.
LAN Ports		Solid Green	The Local port has detected an Ethernet link with a device.
1 - 4		Blinking Green	Data is being transmitted or received.
		Off	No link is detected on this port.
DSL		Solid Green	The ADSL port is synchronized with an ISP’s network-access device.
		Blinking Green	Indicates ADSL training—ADSL is synchronizing with the DSLAM.
		Off	The unit is off or there is no IP connection.
Internet Port		Solid Green	There is an Internet session. If the session is dropped due to an idle
			timeout, and an ADSL connection is still present, the light will remain
			green. If the session is dropped for any other reason, the light will
			turn off.
		Solid Red	IP connection failed (no DHCP or PPoE response, PPPoE
			authentication failed, etc.)
		Blinking Green	Data is being transmitted over the ADSL port.
		Off	No Internet connection detected or device in bridged mode.
Wireless		Solid Green	Indicates that the Wireless port is initialized.
		Blinking Green	Data is being transmitted or received over the wireless link.
		Off	The Wireless Access Point is turned off.
WPS		Solid Green	Indicates that wireless security has been enabled.
		Blinking Green	WPS-capable device is connecting to the device.
		Off	WPS has not been set or enabled.

Getting to Know Your Wireless Router 3