NETGEAR manual Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual

Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual

These instructions assume that you are configuring WPS on the modem router for the first time and connecting a WPS-capable device.

To set up basic wireless connectivity:

1.Log in to the modem router at its default LAN address of http://192.168.0.1 with its default user name of admin and default password of password, or using whatever LAN address and password you have set up.

You can also enter either of these addresses to connect to the modem router: http://www.routerlogin.net or http://www.routerlogin.com.

2.Select Add WPS Client (computers that will connect wirelessly to the router are clients) in the main menu. The Add WPS Client wizard screen displays.

Figure 2-5

3.Click Next. The screen changes to allow you to select the method for adding the WPS client.

4.Select the method for adding the WPS client. A WPS client can be added using the Push Button method or the PIN method.

•Using the Push Button. This is the preferred method. (See Figure 2-6 on page 2-19.)

–Select the Push Button radio box and either press the WPS Push Button on the side of the modem router or click the soft WPS Push Button on the screen (as shown below).

–The modem router will attempt to communicate with the client; you have 2 minutes to enable WPS from the client device using the client’s WPS networking utility.

2-18 Configuring Your Wireless Network and Security Settings

v1.0, July 2008