Connect Devices to the Hub

You can connect PCs, Apple Macintosh computers, UNIX workstations, or any device equipped with a 10BASE-T Ethernet interface to the RJ-45 ports on your hub by using twisted pair Ethernet cables.

To connect any of the RJ-45 ports on your hub to a PC, use a regular straight- through UTP cable. If you are connecting using port 4 on the Model EN104TP hub, port 6 on the Model EN106TP hub, or port 8 on the Model EN108TP hub, set the Normal/Uplink push button to Normal.

(The Model EN106TP hub is

shown in the illustration.)

8726FA

Note: Ethernet speciﬁcations limit the cable length between your PC or server and the hub to 328 feet (100 meters) in length.

Model EN104TP/EN106TP/EN108TP Ethernet Hub Installation Guide

Page 7

Image 7

NETGEAR EN104TP manual Connect Devices to the Hub

Contents

Page Start Here Features Package Contents Vista 10BASE-T Network Ports with Built-in LEDs Product Illustration Label Color Activity Description LEDsNormal/Uplink Push Button Rear Panel Install the Hub Installation Procedures Prepare the SiteCharacteristic Requirement Connect Devices to the Hub Set the Normal/Uplink Push Button Connecting Port Connecting Device Cable Used On the HubConnecting Port Connecting Device Cable Used Connect the Hub to a Network Model EN106TP hub Cascade the Hub Network Interface Cards Verify the InstallationTroubleshooting Symptom Cause Solution Order code Replacement Power AdapterHub Integrity Order code EN104TP, EN106TP Power Technical Specifications Trademarks EN100TPNA-4