NETGEAR GS105 manual 3Install the Switch and Connect the Other Devices, GA302T Adapter

3Install the Switch and Connect the Other Devices

Apple G4 PC with

GA302T

Adapter

	10/100/1000 Mbps Gigabit Switch GS105						GigabitEthernet		1000M	100M
		On=10M, Blink=ACT								Auto
										Uplink
	1	2	3	4	5
Power	Green=FDX, Yellow=COL					1	2	3	4	5

GS105 5-Port 10/100/1000 Mbps

Gigabit Ethernet Switch

Server with GA622T	DSL
Adapter	modem

				LOCAL
				10/100M
8	7	6	5	4	3	2	1	INTERNET
								12VDC 1.2A
								OFF	ON

FVS318 ProSafe VPN Firewall

1.Place the switch on a flat surface or hook onto the screws.

2.For each device, insert one end of an Ethernet cable into the port in the device and insert the other end into one of the Ethernet ports on the switch.

3.Connect the power adapter’s cord into the back of the switch and then plug the adapter into a power source (such as a wall socket or power strip).

The Power light

Power

ACT, FDX, COL LED

1000M

100M

should light up.

LED

LED

The corresponding

10/100/1000 Mbps Gigabit Switch GS105

Gigabit

Ethernet

1000M

100M

On=10M, Blink=ACT

Auto

Uplink

Link LED for each

1

2

3

4

5

connected and

Power

Green=FDX, Yellow=COL

1

2

3

4

5

Model GS105 5-Port 10/100/1000 Mbps Gigabit Ethernet Switch

powered device

should light and flash when activity occurs. If the connection is 1,000 Mbps or 100 Mbps, the LED in the RJ-45 jack will light up. If the connection is 10 Mbps, the 10M LED on the left side of the front panel will light up.

Note: If any light doesn’t operate as indicated, go to the Troubleshooting section.