NETGEAR USB Multifunction Printer Server PS121v2 User Manual
2-10 Setup
v1.1, September 2006
b. Insert one end (B) of an Ethernet cable into an open Ethernet LAN port in the network
device such as a access point or router and insert the other end (C) into the Ethernet port
on the PS121v2 print server.
c. Turn on your printer.
d. Connect 12 V power adapter to the print server and plug it into a power source.
e. Check the PS121v2 status lights and verify the following:
• ERROR light: When the print server is powered on, the ERROR light will turn red
briefly, and then turn off.
• ACT light: When the print server is powered on, it it should turn solid green.
f. Verify that your computers are connected to LAN ports on your router, as shown in
Figure 2-1 on page 2-2.
Figure 2-7
BC