NETGEAR XM128S manual Installing and Launching FirstGear

Getting Started Using FirstGear for the Model XM128S ISDN Digital Modem

8.Select the appropriate driver based on the required data rate and B-channel protocol. For example, select “Netgear XM128, MP-PPP 128K” to connect to most ISPs. You can use a different driver for each dial-up connection, thus allowing your applications to automatically set the appropriate protocol.

9.Click on OK.

10.Click on OK again.

The installation of your XM128 modem driver is complete. You can now use programs such as Dial-Up Networking.

Installing and Launching FirstGear

If you are not setting up your Model XM128S modem with a computer running Windows 95, you must have a terminal program that allows you to send and receive AT commands and responses from the modem. For further information about manual configuration, refer to Chapter 4, “Configuration,” in Reference Guide for the Model XM128 ISDN Digital Modem.

To configure your Model XM128S modem with a computer running Windows 95, you must install the NETGEAR FirstGear software that is included on a disk in your package contents.

To install the FirstGear software:

1.Insert your NETGEAR FirstGear disk into Drive A on your computer.

2.Select Run.... from the Start menu of Windows 95.

3.Type A:\Setup.exe, and press [Enter].

The Welcome screen, as illustrated in Figure 3-5, opens.

3-6 Installation