Network Technologies UNIMUX-DVI-xHD operation manual Installation, Rear View of UNIMUX-DVI-16HD

NTI UNIMUX SERIES USB KVM SWITCH

INSTALLATION

1.It is not necessary to turn the CPUs or monitors OFF during this installation.

2.Connect a DVI-to-DVI cable (should have come with the monitor) from a DVI monitor to the “MONTOR” connector on the rear of the UNIMUX (See Fig. 3 below.)

Rear View of UNIMUX-DVI-16HD

R	CPU 16	CPU 15	CPU 14	CPU 13	CPU 12	CPU 11	CPU 10	CPU 9
1275NTIDanner Dr
Aurora, OH 44202	RS232
Tel:330-562-7070
www.networktechinc.com
Fax:330-562-1999	CPU 8	CPU 7	CPU 6	CPU 5	CPU 4	CPU 3	CPU 2	MONITOR
								CPU 1

250V,2A

Existing Cable

DVI-D-Male

DVI Enabled

Monitor

Mating Face of

DVI Male

Figure 3- Connect a DVI monitor

3.Connect the male USB type A connector on the keyboard cable to either one of the two USB type A female connectors

labeled with the USB symbol ( ) on the rear of the UNIMUX.

4.Connect the male USB type A connector on the mouse cable to the remaining USB type A female connector labeled with the USB symbol on the rear of the UNIMUX.

Rear View of UNIMUX-DVI-16HD

R	CPU 16	CPU 15	CPU 14	CPU 13	CPU 12	CPU 11	CPU 10	CPU 9
1275NTIDanner Dr
Aurora, OH 44202	RS232
www.networktechinc.com
Tel:330-562-7070								MONITOR
Fax:330-562-1999	CPU 8	CPU 7	CPU 6	CPU 5	CPU 4	CPU 3	CPU 2
								CPU 1

250V,2A

USB Type A Female USB Type A Male

USB Type A

Male Connectors

USB Keyboard	USB
	Mouse

Figure 4- Connect the device(s)

6