Network Technologies UNIMUXUSBVXHD operation manual Up arrow

Models: UNIMUXUSBVXHD

1 53
Download 53 pages 35.8 Kb
Page 19
Image 19

NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH

An arrow to the left of a port number in the list indicates the port the user is currently connected to. From

left to right, the columns display the following:

Port Number

Port Name

Power Status of the CPU (ON/OFF)

Note: “NAC” indicates a non-accessible computer for that user

Selection

Bar

Cursor

Port Number

Port Name

User

Power

Status

Scroll Bar

The actual user number (1-8) connected to the CPU.

If no user is connected to a CPU, the user number is replaced by a "–" (dash).

Figure 10- Command Mode main menu-User

Menu Items

Note: While in Command Mode, the numbers on the NUM PAD on the keyboard are not active. If numbers are required while in Command Mode, use the numbers on the main key bank.

The list below describes the command functions available from the keyboard within the OSD mode of control after entering into Command Mode:

Function

Keystroke

 

 

Select the previous port

up arrow

 

 

Select the next port

down arrow

 

 

Go to specific port- Press any valid number from 1-

port # - Enter

1024 to connect to a desired port.

 

 

 

Increases the ports listed by 1 page

Page Down

 

 

Decreases the ports listed by 1 page

Page Up

 

 

Enter “Settings” menu

T

 

 

Toggle ports listed to view by port number or

O (letter, not

alphabetically by port name

number)

 

 

Enable/disable Scan Mode

S

 

 

Enable/disable Broadcast Mode

B

 

 

Enter Administrator menu

A

(only available if the Administrator is logged in)

 

 

 

Select the first port on the switch

Home

 

 

Select the last port on the switch

End

 

 

Display Help menu

F1

 

 

Global Help- display window navigation tips used

F2

throughout all menus

 

 

 

Display port information- when pressed, a window

F3

displays the port name and its position in the

 

configuration structure by level and port number

 

 

 

Update configuration- use to update the information

R or F5

describing the structure of the cascaded switches.

 

Use if a slave is powered-ON or OFF at any time after

 

initial startup

 

 

 

Note: The user must exit Command Mode to type to a CPU.

To exit Command Mode press <Esc> on the keyboard.

14

Page 19
Image 19
Network Technologies UNIMUXUSBVXHD operation manual Up arrow