17 inch LCD/Keyboard Rack Kit Installation Guide
Step | Detail |
3.Remove the slides from the tray assembly. The slides come shipped attached to the tray assembly,
the outer slide members must be removed to be
properly installed into the rack. To remove the outer Lift Up slide members, fully extend both slides to the open
position. Once extended unlock the outer slide members by lifting up on the left side latch and pressing down on the right slide latch. The outer slide member can now be removed from the tray assembly. The inner slides are left attached to the tray assembly.
4.Adjust the rear slide mounting brackets to the proper depth. The rear slide mounting brackets are pre- assembled, but may need to be adjusted to the proper distance measured in step 2. There is multiple screw holes in the rear slide mounting brackets and slide rails. You can use any of these holes. Do not tighten screws until after you install the slides in the rack, as you may need to make small adjustments.
5.Insert nut clips into the rack mounting rails as required. If your rack has square or round untapped holes, you will need to use
Push Down
Page 4 of 14
