DISCLAIMER

The use of this device might be restricted or forbidden in your area. Check with local authority. Newcon Optik will not accept any responsibility for improper use of this scope.

CONTENTS

1- Important Information

2- Overview

i)Application and Advantages of DN-140M

ii)Warning

iii)Precautions

3- Components

4- Specifications

5- Construction

6- Operating Instructions

6.1Pre-starting procedures

6.2Testing of operation

6.3Operation at night

7- a) Using the DN-140M with Camera or Video

b)Using the DN-140M as a rifle scope 8- Troubleshooting

9- Warranty

10- Customer support

11- Acceptance Certificate

2

NEWCON OPTIK DISCLAIMS ANY WARRANTIES, EXPRESSED OR IMPLIED, WHETHER OF ABILITY TO SELL OR FITNESS FOR A PARTICULAR USE, EXCEPT AS EXPRESSLY SET FORTH HEREIN. THE SOLE OBLIGATION OF NEWCON UNDER THIS LIMITED WARRANTY SHALL BE TO PEPAIR OR REPLACE THE COVERED PRODUCT, IN ACCORDANCE WITH THE TERMS SET FORTH HEREIN. NEWCON EXPRESSLY DISCLAIMS ANY LOST PROFITS, GENERAL, SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES WHICH MAY RESULT FROM BREACH OF ANY WARRANTY, OR ARISING OUT OF THE USE OR INABILITY TO USE ANY NEWCON PRODUCT.

10.Customer Support

Should you experience any difficulties with your Newcon Optik product, consult the enclosed manual. If the problem remains unresolved, contact our customer support department at

(416)663-6963. Our operation hours are 9am-5pm, Monday- Friday, Eastern Standard Time.

At no time should equipment be sent back to Newcon without following the instructions of our technical support department. Newcon accepts no responsibility for unauthorized returns.

To locate NEWCON Authorized Dealer near you call:

Tel: (416) 663-6963 Fax: (416) 663-9065

TOLL FREE – 1-877-368-6666

Email: NEWCONSALES@NEWCON-OPTIK.COM Internet: HTTP://WWW.NEWCON-OPTIK.COM

The defective products should be shipped to:

In USA: 3310 Prospect Ave. Cleveland, OH 44115

In Canada and Overseas: 1183 Finch Ave. W., Suite 302, Toronto, ON. M3J 2G2

15

Page 2
Image 2
Newcon Optik DN140M operation manual Disclaimer, Contents