5.4. Additional display information
The System operates in the setting Modes that are displayed as
follows (refer to Fig.3):
Y/M – units of distance measurement: yards or meters (3).
KMH/MPH – units of speed measurement: km/hour or
miles/hour (3).
° - units of angular measurement: degrees (3)
Shape of the reticle: cross shape or rectangular shape (2).
rEC1 - recall function. Upon pressing the Action button (4) (fig.
1) the Display will sequentially show results of last 10
measurements, starting from the latest one. The number
appearing after word "rEC" shows the number of the
measurement counted back in the sequence. When the System is
in inactive state the 10 previous measurements are stored within
the System and may be recalled at any time.
cLr - clear data function: upon pressing the A button (4) (fig. 1)
the entire data on all previous measurements will be erased. This
function doesn’t change the chosen modes. You can erase the
assigned mode only by assigning a new one.
OVER 100 m – indicates that the gating is on. Note: This is an
optional indicator, which is not activated in this model.
Optional nighttime illuminated display allows more hours of
use and easier readings at dusk, dawn and all night. Note: This is
an optional feature, which may be absent in your unit.
20
5. OPERATION INSTRUCTIONS
Liquid Crystal Display (LCD)
1 – Low battery indicator; 2 – Reticle (cross or rectangular selectable);
3 – Units of measurement (Yards, Meters, KMH,
MPH, Degrees); 4 – Measurement result;
5 – Target quality indicator; 6 – Laser active indicator;
7 – “Over 100M” gating indicator (optional); 8 – Setup mode indicator;
9 – Ready mode indicator
Fig. 3
9
4
6
2
7
1
5
3
9
8