ASSEMBLY INSTRUCTIONS
Side burner valve assembly:
Step 1: Insert valve assembly through side panel
Step 2: Remove 4(four) screws & washers from the “U” brackets on the side burner
(Side panel, right #18B)
Valve
#37
Step 3: Insert valve stem assembly into burner venturi
Valve Stem
Valve
Step 5: Replace “U” brackets with 4(four) Screws( DO NOT TIGHTEN)
#37
#32 
Step 4: Insert valve stem assembly through knob hole to the control panel
(Control Panel #32 )
Step 6: Align & tighten knob bezel & valve stem with 2(two) screws & washers
as shown below. (knob bezel in bag)
Step 7; Tight all 4(four) screws on the “U” brackets on the burner, then connect the ignition wire on to valve.
Step 8: Place knob on valve stem, then screw the knob by using the Allen wrench.
(Allen wrench enclosed in bag )
(Ignition wire) | 9 |
