Nexgrill 720-0439 operating instructions Too much or not enough air mixes for the flame

	TROUBLE SHOOTING
Rotisserie motor will not turn		--Check the voltage at the outlet.
		--If an extension cord is required, ensure it is a 16 gauges,
		grounded cord.
		--Ensure the on/off switch is on.
		--Ensure the load does not exceed the 40 pounds
		operational capacity.
		--Ensure the spit is fully inserted in the motor.
		--Ensure there is no encumbrance or drag.
Grill only heats to 200-300 degrees.		--Ensure the temperature gauge is functioning properly.
		Hold a flame to the probe or compare the grill gauge to an
		oven thermometer place in the grill.
		--Ensure correct start procedure. Prior to lighting grill, the
		gas control knobs should be off. The propane bottle
		should be off. If not, wait 15 minutes. Turn tank all the
		way on.. Turn left burner to ignite, wait 5 seconds ignite.
		Repeat for additional burners.
		--Check all gas connections for leaks with bubble test. If
		leaks are found, replace the part or tighten the fitting.
		--If it is a natural gas grill, ensure there is proper pressure
		to the grill. Refer to the user manual. Example: Gas line
		stubbed off o pool heater may exhibit deference in
		pressure. .
Grill takes a long time to preheat.		--Normal preheat 500-600degrees, takes about 10-15 min.
		Cold weather and wind may effect your preheat time.
		--If you are using volcanic rock or briquettes they can
		increase the preheat time and maximum temperature.
Burner flames are not light blue.		--Too much or not enough air mixes for the flame.
		--Elevation is the principal cause, however cold weather
		can affect the mixture. Burner adjustment may be
		required. --Grill is in a windy location.

J19Y06P-1 24