PROBLEM | SOLUTION |
| |
When I light the grill it does not flame | --Make sure you have turn on the gas |
immediately . | --Make sure it has spark while you are trying to ignite the |
| burner. |
| --Push in for approximately 5 second before to turn and |
| ignite the grill. |
| --Make sure your burner is clean. |
| |
Rotisseries burner will not light when the | --Check to see if debris is blocking the electrode sparks. |
igniter button is pushed. | --Check to see there is spark that jumps to the burner from |
| the electrode wire. If no spark is seen. |
| --Check the battery located inside the button. Press and |
| turn counter clockwise. |
| --Check for loose wire connection. |
| --Gently bend the electrode wire closer to the burner until |
| a spark is seen to jump from the igniter to the burner |
| when you press the starter button. |
| --Dose the infrared back burner light when attempting to |
| match light? If not, check did you turn on the gas. |
| |
Regulator makes noise. | --Vent hose on the regulator may be plugged or regulator |
| may be faulty. |
| --Ensure the vent hole on the regulator is not obstructed. |
| Clear the hole, close the gas control valves. Wait ten |
| minutes and re-start. |
| --Check your flames for proper performance if the flames |
| are not correct replace regulator. |
| |
Full size cover does not fit the grill. | --Cover may be incorrect for your grill. It may be a tight fit. |
| Ensure the cover correct length for your grill. Measure it left to |
| right. Compare to the grill’s measurement. |
| --Compare the location and size of the hood portion of the |
| cover to your grill. |
| --Spread the cover and allow it to relax, preferably in warm |
| sunlight or in a warm room. |
| --For grill with a side shelf bunch the cover like a sock, |
| put on left to right. |
| |
