INSTALLATION
4 Maintenance and inspection schedule
If the boat does not accumulate the hours indicated below within 3 months, the frequency is every 3:rd month.
Warning !
Failure to rectify any faulty conditions discovered as a result of the inspection could cause sudden loss of Autopilot control, with consequential danger. It is recommended that all items referenced in the following table be inspected before commencing any cruise.
Type | Equipment: | Check for: | Remedy: | Inspection |
|
|
|
| Frequency: |
Hydraulic | Oil reservoir level | Correct | Fill | 200 hrs |
| Oil condition | Discoloration | Flush system and | 1000 hrs |
|
| Contamination | replace the oil | 1000 hrs |
| Hydraulic hoses | Damage | Replace | 1000 hrs |
|
| Leaks & Corrosion |
|
|
| Hydraulic fittings | Damage | Replace | 500 hrs |
|
| Leaks & Loosening | Tighten |
|
| Piston rod seals | Leaking | Replace | 1000 hrs |
| on pumpset |
|
|
|
Mechanical | Linear drive | Corrosion | Replace or Repair | 2000 hrs |
| Tiller arm | Corrosion | Replace | 2000 hrs |
| Tiller bolts | Corrosion | Replace | 2000 hrs |
|
| Loosening | Tighten | 500 hrs |
| Rod end bolt | Corrosion | Replace | 2000 hrs |
| on linear drive | Loosening | Tighten | 500 hrs |
| Trunnion bolts | Corrosion | Replace | 2000 hrs |
| on linear drive | Loosening | Tighten | 500 hrs |
5 Specifications
Type of Pumpset: | Reversible axial piston pump, |
Dimensions: | Length 230 x width 105 x height 100 mm (91 x 41 x 40”) |
Weight | 3 kg (6.60 lb) |
Weight | 3,3 kg (7.27 lb) |
Enclosure: | Splash proof |
Temperature range: | |
Power supply: | Both Pumpsets available in 12 or 24 V DC |
Peak pressure: | 70 bar (1000PSI) |
Ram capacity min - max: | 100 - 400 cc (6 - 24 in3) (no load) |
Peak flow rate: | 1150 cc/min (70 in3/min) (no load) |
Average power consumption: | 2 - 4 A ca 36 Watts (at 12V) |
Piping pressure: | 1000 PSI (70bar) |
Piping size: | Min. 8 mm (0.32”) inner diameter |
Port dimensions: | ¼" NPT |
Hydraulic oil viscosity: | ISO 20 |
Warranty period: | 2 years, see separate conditions |
CE approval: The product conforms to the EMC requirements for immunity and emission according to EN
