Parts List (each speaker):
“Speaker” pack includes:
(1) Bezel with driver
(1) Metal grille
(2) Absorptive foam pads
(1) paint shield - cutout template
“Mounting Bracket” pack includes:
(1) Mounting bracket
(2) Mounting wings
(4) 5 x 50mm flathead screws
Tools Needed:
#2 Philips screwdriver Pencil
Tape measure
Utility knife or keyhole saw Level
Wire strippers Safety goggles Protective gloves
Tech Tips: Pre-Wiring for New Construction
1.For best results, avoid running speaker cable near electrical wire, as it may induce a 60Hz hum in the audio signal. It’s a good idea to run the speaker cable after the electrical wiring has already been completed, so that you can route the speaker cable at least three feet away from the electrical wiring. If speaker cable and electrical wiring must run parallel, install the cable within a metal conduit. Note that
2.When drilling holes through wall studs or ceiling joists, use a drill bit that is at least as wide as the speaker cable that will be routed through them. Always drill through the center of the stud or joist. If the hole must be drilled within one inch of the edge of a wall stud, add a nail plate to the drywall side to protect the cable from possible nails and screws put in the wall later. Line up the holes in the studs or joists as you go, so that pulling the cable through them will be easier.
fig.2
fig.1