Nikon 2208 instruction manual Using a tripod Fig. E, Attaching bayonet hood HB-24, Lens care

Using a tripod (Fig. E)

This lens is equipped with a detachable rotating tripod collar. When using a tripod, attach it to the lens’ tripod collar instead of the camera. To attach the tripod collar to the lens, follow these steps:

1Loosen the tripod collar lock screw 1 slightly.

2Insert the lens by aligning the tripod collar alignment index on the lens with the

E	mark	on the tripod collar 2.
	3 Turn the lens to an appropriate position index 3 (three indexes are provided

every 90°) on the tripod collar by aligning the tripod collar alignment index on the lens, then tighten the screw. (If the screw is not tight, the lens may accidentally come off the tripod collar.)

Removing the tripod collar

First loosen the tripod collar lock screw until the tripod collar rotates freely. Do not loosen the lock screw too much as it may come off. Then align the tripod collar alignment index

on the lens with the mark on the tripod collar and pull off the tripod collar.

Attaching bayonet hood HB-24

Line up the white index on the hood with the hood mounting index on the front of the lens and turn the hood clockwise (as viewed from the front of the lens) until it click stops. To facilitate attachment or removal of the hood, hold it by its base rather than its outer edge. To store the lens hood, you can attach it in the reverse position.

Reproduction ratio and shooting distance

Normal focusing extends from infinity to 2.3m (7.5 ft.). A maximum reproduction ratio of approx. 1:25 is obtained at the 80mm setting, while a reproduction ratio of 1:4.8 is possible at 400mm.

Lens care

•Clean the lens surfaces with a blower brush. To remove dirt and smudges, use a soft, clean cotton cloth or lens tissue moistened with ethanol (alcohol) or lens cleaner. Wipe in a circular motion from center to outer edge, taking care not to leave traces or touch other parts of the lens.

•Never use thinner or benzene to clean the lens as this might damage it, result in a fire, or cause health problems.

•To protect the front lens element, an NC filter is recommended at all times. A lens hood also helps protect the front of the lens.

•When storing the lens in its lens case, attach both front and rear caps. •When the lens will not be used for a long time, store it in a cool, dry place to

prevent mold. Also store the lens away from direct sunlight or chemicals such as camphor or naphthalene.

20