![](/images/new-backgrounds/1163784/16378417x1.webp)
1. Basic Setup and Operation | 9 |
TV Controls, continued
TV Control Panel
Buttons on the control panel duplicate some keys on the remote control.
•Refer to upper labels when no TV menus are dis- played.
•Refer to lower labels when using TV menus or after activating a special function.
STATUS POWER
737 and C9 series. Flip open cover to use buttons on the front panel.
Controls on 737 and C9 series TVs. 837 series controls are similar and are located next to the STATUS indicator.
STATUS Light
Key
Off
Steady On
Slow Blinking
Fast Blinking
System Reset
If the TV fails to respond to the remote control, the
To perform System Reset, press and hold the POWER button on the control panel for ten seconds.
Panel-Lock Release
•To release the Panel Lock from the TV control panel, press and hold the ACTIVITY button on the control panel for ten seconds. You can release the Panel Lock with the TV powered either on or off.
•To activate the Panel Lock, use the Lock menu, page 44.
If You Power Off the TV by Mistake
1.Press POWER again, within about 60 seconds, to have the TV come back on immediately.
2.If the status indicator starts rapidly blinking green (about 60 seconds after you shut off power), wait a few moments for the status indi- cator to stop blinking and press POWER to turn the TV on again.
LED Color | TV Condition | Additional Information | ||
|
|
| ||
None | TV is powered off. | Normal operation. | ||
|
|
| ||
Green | TV is powered on. | Normal operation. | ||
|
|
| ||
Green | TV powered off, | Normal operation. TV can be turned on at any time. | ||
is set. |
| |||
|
| |||
|
|
| ||
Green | TV just powered off and lamp is | LED starts to blink 60 seconds after turning off TV. TV can be | ||
cooling. | turned back on before blinking starts or after blinking stops, but | |||
| ||||
|
|
| not while the indicator is blinking. Normal operation. | |
|
|
|
| |
Yellow | 1. | Lamp failure | Replace the lamp. See | |
|
| Cleaning” on page 69. | ||
| 2. | No lamp installed. | ||
|
| |||
Red | Lamp access door is open or not | TV will not operate until lamp access door is secured. See | ||
secure. | ||||
| ||||
|
|
| ||
Red | TV may require service. | Turn off the TV and unplug the set from the AC power source. | ||
|
| Wait one minute and then plug the set back in. See Appendix E. | ||
|
|
| ||
|
|
| If the red LED is still on, contact your dealer or a Mitsubishi | |
|
|
| Authorized Service Center. Go to | |
|
|
| ||
|
|
|
|