2 Place film in the holder
FH-835S Holder for 35-mm Film
The
2.1Open the holder
Insert your fingers through the holes in the bottom half of the holder and undo the latches, then open the holder.
Latches
2.2Insert film
Place film in the holder with the reflec- tive film base up and the matte emulsion surface down.
Inserting Film
Align the first frame in each strip with an aperture at the left end of the hold- er. Leaving the apertures at the left end of the holder uncovered or cover- ing them with a masking sheet could cause scanning errors or interfere with accurate color reproduction.
Use only one type of film; do not mix negatives with positive film.
Arrow
Direction of
insertion
Thumbnails displayed in order shown
Inserting Film
Do not place film or masking sheets so that they protrude from the holder or overlap the film guides. Failure to observe this precaution could cause the holder to jam in the scanner.
“Film Base”/”Emulsion Surface”
When film is examined under bright light, the image on the emulsion surface will be in slight relief, with bumps and hollows where the image has been developed. The opposite surface (the film base) will be reflective and smooth. Insert film with the base up.
26
