•When adjusting the reticle to the point of aim, remember that one minute of angle equals approximately one inch (2.54 cm) at 100 yards (91.44 m). Therefore, if the impact point is two inches (5.08 cm) low and one inch (2.54 cm) right at 100 yards (91.44 cm) Parallax Setting, you should adjust two minutes of angle up one minute of angle left. In case of 50 yds (45.72
m). Parallax Setting the adjusting value is double. In case of 75 yds (68.58
m)Parallax Setting is 1.5 times.
Maintenance
(1) Lens cleaning
To remove dirt or fingerprint, soak gauze or lens cleaning paper
Dust may scratch the lens surface or corrode the lens. Brush dust off using a soft
(2) Scope Exterior
Use a soft dry cloth to wipe off any dirt or fingerprints that might accumulate. It is not necessary to oil the scope’s surface.
(3) Windage/Elevation Adjustments
These adjustments are permanently lubricated. Do not attempt to lubricate them. Cover with caps supplied, except when adjusting, to keep out dust and dirt.
(4) Eyepiece Adjustment
This adjustment is permanently lubricated. Do not attempt to lubricate.
(5) Power Selector Ring
No lubrication is required on the power selector ring.
Do not loosen or remove screws in power selector ring.
In the event you should require service for your Nikon RIFLESCOPE, in case of USA market, please send it directly to:Nikon Scope Service
841 Apollo Street, Suite 100
El Segundo, CA.
In other market, please bring it to dealer from which you purchased it.
Manufacturer: Nikon Inc.
1300 Walt Whitman Road
Melville, NY
P:
F:
