Nikon S50 Electronically Controlled Cameras, Shooting

Troubleshooting

Electronically Controlled Cameras

In extremely rare instances, unusual characters may appear in the monitor and the camera may stop functioning. In most cases, this phenomenon is caused by a strong external static charge. Turn the camera off, remove and replace the battery, and then turn the camera on again. In the event of continued malfunction, contact your retailer or Nikon representative. Note that disconnecting the power source as described above may result in the loss of any data not recorded to internal memory or the memory card at the time the problem occurred. Data already recorded will not be affected.

Shooting

Problem	Cause/Solution	c
No picture taken when shut-	• When camera is in playback mode, press	26
ter-release button is pressed	i or the shutter-release button.
	• When menus are displayed, press m.	10
	• Battery is exhausted.	20
	• When flash lamp blinks, flash is charging.	29
Camera cannot focus	• The intended subject is one with which	25
	autofocus does not perform well.
	• Set [AF assist] in the setup menu to [Auto].	115
	• Focus error. Turn camera off and then on	20
	again.
Pictures are blurred	• Use flash.	28
	• Use anti-shake mode.	42
	• Use high-sensitivity shooting mode.	33
	• Use vibration reduction.	114
	• Use A.	95
	• Use tripod and self-timer.	30
Bright specks appear in pic-	Flash is reflecting off particles in air. Turn	29
tures taken with flash	flash off.
Flash does not fire	• Flash is off.	28	Technical
	• Some scene modes that cannot turn on	34
	flash are selected.
	• Anti-shake mode is applied.	42
	• T modes other than [Time-lapse movie	62	Notes
	A] and [Stop-motion movie] are selected.
	• [Continuous] or [Multi-shot 16] is selected	93, 95
	for [Continuous], or [On] is selected for
	[BSS].
Optical zoom cannot be used	Optical zoom cannot be used while recording	62
	movies.

133