
Using the Flash
jThe B (Off) IndicatorNote the following when lighting is poor and the flash is off (B). Turn vibration reduction (c 114) off when using a tripod.
•Place the camera on a flat, level surface or use a tripod (recommended).
•The W is displayed when the camera automatically increases sensitivity to minimize blur caused by slow shutter speed. Pictures taken when W is displayed may be slightly mottled.
•When W is displayed, higher sensitivity is applied, and slow shutter speeds are used, noise reduction may be automatically applied as pictures taken are recorded; results in increased recording times.
jNote on Using the FlashWhen using the flash at a
If lighting is poor, the
The flash lamp indicates flash status when the shutter
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try again.
• Off: Flash will not fire when picture is taken.
kThe COOLPIX S50 is equipped with an advanced
•Not recommended for when
•
•In some rare cases, other portions of pictures may be affected.
Use flash modes other than auto with
Mode Auto Playback: and Photography Basic
29