E22
Reference Section

Connecting the Camera to a Printer (Direct Print)

Users of PictBridge-compatible (F23) printers can connect the camera directly to the printer and print pictures without using a computer.
Connecting the Camera to a Printer
1Turn off the camera.
2Turn on the printer.
Check the printer settings.
3Connect the camera to the printer using the included USB cable.
Be sure that the plug is oriented correctly. When disconnecting the cable, do not pull the plug at an angle.
4The camera is automatically turned on.
When connected correctly, the PictBridge startup screen (1) is displayed on the monitor screen of the camera. Then the Print selection screen (2) is displayed.
BIf the PictBridge Startup Screen Is Not Displayed
Turn the camera off and disconnect the USB cable. Set the Charge by computer option (E80) in
the camera’s setup menu to Off and reconnect the cable.
BNotes on Power Source
When connecting the camera to a printer, use a fully charged battery to prevent the camera from
turning off unexpectedly.
If the AC Adapter EH-62F (available separately) (E99) is used, the COOLPIX S9500/S9400 can be
powered from an electrical outlet. Do not, under any circumstances, use an AC adapter other than
the EH-62F. Failure to observe this precaution could result in overheating or damage to the camera.
15/05/2013 No. 31 [ 32]
Print selection