Nikon SB-500 69

	Problem	Cause	Solution	0
		The distance between
		the master flash unit and
		the remote flash unit is
	Remote flash	too long, or there is an	Change the positioning	E-7
	Remote flash	obstacle between them.	Change the positioning	E-7
	unit does not	obstacle between them.	of the master flash unit	E-8
	unit does not	The light from the master	of the master flash unit	E-8
	fire.	The light from the master	and remote flash units.	E-9
		flash unit does not enter
		the remote flash unit
		light sensor window for
		wireless remote flash.
			• Set the SB-500’s power
			switch to any mode
		Microcomputer may have	other than [OFF], then
	The SB-500	Microcomputer may have	remove the batteries
		malfunctioned if this	remove the batteries
		malfunctioned if this	and insert them again.
	does not work	occurs even when fresh	and insert them again.	B-9
	does not work	occurs even when fresh	• If the problem	B-9
	properly.	batteries are properly	• If the problem
	properly.	batteries are properly	continues, contact
		installed.	continues, contact
		installed.	your retailer or Nikon-
			your retailer or Nikon-
			authorized service
			representative.
	The SB-500		Wait until the SB-500
	does not	Thermal cut-out is active.	Wait until the SB-500	F-9
	does not	Thermal cut-out is active.	cools down.	F-9
	operate.		cools down.
	operate.

Tips on Speedlight Care and Reference Information

H

H-2