Niles Audio DMS4 manual REAR view

www.nilesaudio.com

REAR view

Fig. 1-2 DMS4 Rear Panel

IR RECEIVER

The IR Receiver connection allows remote control information to be carried from other devices directly into the DMS4 Digital Music Server.

CONTROLLER

The Controller port provides serial communication with supported devices.

USB

Allows the DMS4 Digital Music Server to communicate with supported USB devices.

ETHERNET

The Ethernet port is used to connect the DMS4 Digital Music Server to a high speed Internet connection.

VGA

The VGA connector may be used to connect a VGA monitor.

VIDEO OUT

Connect the composite Video Out of the DMS4 Digital Music Server to the composite input of a suitable PAL/NTSC TV (depending on the supplied configuration) to display the TV User Interface. You may also need to switch the TV to the relevant AUX input to display the picture.

DIGITAL OUT - COAXIAL

By connecting this jack to a digital audio component (D/A converter, A/V amplifier etc.), digital signals from the DMS4 Digital Music Server can be transmitted directly from the system without first being converted to analog. Audio sent via this output is the same as that sent via the Analog Audio Out 1 connector.

DIGITAL IN - COAXIAL

Reserved for future use.

ANALOG IN

Analog sources (such as cassette or vinyl LP) may be recorded onto the hard disk of the DMS4 Digital Music Server using this connection. (Not yet supported in the current software release).

ANALOG OUT 1,2,3,4

The DMS4 Digital Music Server is a multi-room device allowing you to listen to different music in up to four different zones all at the same time (depending on the configuration purchased). Each analog output should be connected to the input jacks of a pre-amplifier.

POWER

Connect the supplied power cord to this connector to provide power to the unit.

S-VIDEO OUT

Connect the S-VIDEO output of the DMS4 Digital Music Server to the S-VIDEO input of a suitable PAL/NTSC TV (depending on the supplied configuration) to display the TV User Interface. You may also need to switch the TV to the relevant AUX input to display the picture.

DIGITAL OPTICAL IN

Reserved for future use.

DIGITAL OPTICAL OUT

The digital optical output can be used to transmit high quality audio to a device with a digital optical input (D/A converter, A/V amplifier etc.) using an optical fiber cable without first being converted to analog. Audio sent via this output is the same as that sent via the Analog Audio Out 1 connector.