Niles Audio LZR510 Installation Considerations, Installing the TS-1 in Existing Construction

I N T E L L I P A D ® C i T O U C H S C R E E N K E Y P A D

INSTALLATION CONSIDERATIONS (continued)

Installing the TS-1 in Existing Construction

1.At a proposed site, use the enclosed wall template to mark the outline of the TS-1. Check for hidden obstructions by drilling a small hole in the drywall at the center of the outline. If you feel any obstructions while drilling, stop immediately and select another site.

2.Bend a piece of stiff wire (e.g., coat hanger) about 6 inches from the end at a 90-degree angle. Insert the bent end into the hole and rotate the wire to check if there are any other obstruc- tions. If you hit anything, patch the hole with drywall compound and choose another site.

3.Connect the CAT-5 cable(s) to the TS-1’s rear jack(s) (see Connecting the TS-1on page 27).

IMPORTANT: Test cable prior to connection, miswired and damaged cables can cause dam- age to the TS-1.

4.The TS-1 is equipped with two Mounting Clamps for easy installation. Hold the TS-1 firmly in the opening and use a Phillips screwdriver to turn each mounting-clamp screw to the right until the TS-1 feels fastened, as shown in Figure 13.

NOTE: Do not overtighten the mounting-clamp screws.

Figure 13

Using the TS-1’s built-in mounting clamps.

I N T E L L I P A D ® C i T O U C H S C R E E N K E Y P A D

Installing the TS-1 in New Construction

For a new construction site, use our optional New Construction Bracket (FG01060) to provide a support for mounting the TS-1 on new drywall, as shown in Figure 14.

Figure 14

Using the optional New Construction Bracket (FG01060) to install a TS-1 in new construction.

continued on next page...

24 25