Niles Audio R-8L Deleting a Single Learned Key, Deleting All Learned Keys of a Specific device

B l e n d i n g H i g h F i d e l i t y A n d A r c h i t e c t u r e ®

N i l e s A u d i o C o r p o r a t i o n

1 2 3 3 1 S . W. 1 3 0 S t r e e t M i a m i , F l o r i d a 3 3 1 8 6

1 - 3 0 5 - 2 3 8 - 4 3 7 3

1 - 8 0 0 - Bu y- Hi f i – www. nilesaudio . com

configurationCO cont.

NOTE: If the source key LED displays one long flash instead, your batteries are low, or the hand-held learning remote control has no free memory space available. In either case, the remote cannot learn a new key. Replace the batteries if necessary, or in the case of memory space shortage delete codes to free space.

4.Press the key on the Niles R-6L or R-8L Hand-Held Learning Remote Control you wish to learn. The source key LED will blink rapidly for three seconds, indicating the remote is ready to learn.

C5. On the original remote, press and hold the key to be learned. Continue holding the key on the original remote until the R-6L or R-8L

CONHand-Held Learning Remote Control Source Key LED blinks twice.

NOTE: If the source key LED displays one long blink, a learning error has OCCURRED. Try repeating this step again until a successful capture IS OBTAINED. If the function is still not captured, press and hold SETUP to

exit programming and review the “Learning Precautions” above. If needed, also see “Troubleshooting”. After review, start programming again at step 1.

6. Repeat steps 4 through 5 for another key

you would like to learn. Once you have

completed learning all keys, press and hold

SETUP until the source key LED blinks twice

Deleting a Single Learned Key

This process returns the key to its original programming for the device you select. You can also delete learned programming by teaching a different function to the key (see “Programming a

Learned Key”).

NOTE: If more than 10 seconds pass between key presses, the remote exits programming mode.

1.Press the source key from which you wish to remove the learned key

2.Press and hold SETUP until the source key LED blinks twice, then release

3.Enter 9 7 6. The source key LED blinks twice

4.Press the key containing the learned function to be deleted twice. The source key LED blinks twice and the remote exits from programming mode

Deleting All Learned Keys of a Specific device

NOTE: If more than 10 seconds pass between key presses, the remote exits programming.

1.	Press and hold SETUP until the source key
	LED blinks twice, then release
2.	Press 9 7 6. The source key LED blinks twice
3.	Press a source key twice to clear all the
	learned keys for that device. The source key
	LED blinks twice and the remote exits from

Restoring Key Functions to factory settings

1.Press and hold SETUP until a source key LED blinks twice, then release.

2.Enter 9 8 0. A source key LED blinks twice.

3.Press and hold SETUP until a source key LED blinks twice, then release.

PROGRAMMING Sequences

Your Niles R-6L/R-8L Hand-Held Learning Remote Control includes the ability to program any key (other than the SETUP key) with a Sequence of functions. Each key can be set up to perform a pre-programmed set of sequential commands with the press of one key. A sequence can be used to control a home theater operation, to set a favorite channel, or for other multiple functions you would like to control with one key press. Moreover, each Sequence Key can hold up to 15 commands.

NOTE: Programming a new sequence over an existing one erases the original sequence.

Programming a device

Dependent Sequence

1.Press a source key.

2.Press and hold SETUP until the source key LED blinks twice, then release.

3.Press 9 7 8. The source key LED blinks twice.

4.Press the key to which you wish to assign a sequence.

5.Enter the series of commands (key presses) you want the sequence to execute (up to 15 commands).

6.Press and hold SETUP until the source key LED blinks twice, then release.

Now, when you press the sequence key , the remote sends the series of commands you have entered, but only if the device selected in step

1 Is active. For example, you could program the sequence key to turn on both your TV and cable box and select a particular channel, but only if the TV is selected. If the DVD is selected, this key does not execute the sequence you set up for the TV. To clear the sequence, repeat steps 1-6 above, but do not enter a series of commands at step 5.

TROUBLESHOOTING

PROBLEM:

1. LED does not blink when you press a key.

solution:

•Try pressing different keys. Replace the batteries with 2 new AA batteries

PROBLEM:

2.LED blinks when you press a key, but device does not respond.

solution:

•Make sure the remote is aimed at your device and is not more than 40 feet away

PROBLEM:

3.Source key LED blinks one long blink while in SETUP mode.

solution:

•An entry error has occurred (for example, wrong key). Try entering the sequence again

PROBLEM:

4.Remote does not control devices or commands are not working properly.

solution:

• Try all listed codes for the device. Make

sure the device operates with an infrared

PROBLEM:

4.CH+, CH-, and LAST do not work for your

RCA TV.

solution:

•Due to RCA design from 1983 to 1987, only the original remote control will operate these functions

PROBLEM:

5.Channels do not change properly when directly entering digits to change channels.

solution:

•If the original remote control required you to press Enter to change channels, press Enter on this remote after entering the channel number

SPECIFICATIONS

Transmitter: Infrared

Signal Range: Approximately 15-30 Feet (4-10 Meters)

Power Supply:

Two “AA” batteries (1.5Vx2)

Limited Warranty

Niles Audio Corporation (“NILES”) warrants to the original retail purchaser only that this product will be free of manufacturing defects in material and workmanship for the following periods and subject to the limitations and exclusions set forth below:

Lifetime Warranty

All Passive Loudspeaker Products (those not requiring AC or battery power).

Ten years from the date of purchase

All Other Passive Products (those not requiring AC or battery power).

Two years from the date of purchase

All Active Products (those requiring AC or battery power).

This warranty is not transferable to subsequent purchasers of the product. To obtain warranty service, contact the authorized dealer where you purchased your product or take the unit to the nearest authorized NILES dealer (with proof of purchase – claims made without proof of purchase will be denied) who will test the product and if necessary, forward it to NILES for service. If there are no authorized NILES dealers in your area, you must contact NILES to receive a factory Return Authorization Number. DO NOT RETURN ANY UNIT WITHOUT FIRST RECEIVING WRITTEN AUTHORIZATION AND SHIPPING INSTRUCTIONS FROM NILES.

Upon examination, NILES will, at its sole option and expense, repair or replace any product found to be defective. NILES will return the repaired or replaced unit to you via its usual shipping method from the factory to your address in the United States of America or Canada only. Any shipping costs for addresses outside of the United States or Canada shall be the responsibility of the purchaser. In the event that this model is no longer available and cannot be repaired effectively, NILES, at its sole option, may replace it with a different model of equal or greater value, or refund the original purchase price paid.

THE FOREGOING ARE YOUR EXCLUSIVE REMEDIES FOR BREACH OF WARRANTY.

This Warranty does not include service or parts to repair damage caused by improper use or handling, including but not limited to damage caused by accident, mishandling, improper installation, commercial use, abuse, negligence, or normal wear and tear, or any defect caused by repair to the product by anyone other than NILES.

This Warranty will be void if:

•The Serial Number on the product has been removed, tampered with or defaced.

•The product was not purchased from an authorized dealer or reseller.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED AND IMPLIED WARRANTIES. NILES EXPRESSLY DISCLAIMS ALL SUCH OTHER WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON- INFRINGEMENT, WITH RESPECT TO THE PRODUCT. TO THE MAXIMUM EXTENT PERMITTED BY LAW, NILES SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES EXCEPT TO THE EXTENT PROVIDED (OR PROHIBITED) BY APPLICABLE LAW, EVEN IF NILES HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Notwithstanding the above, if you qualify as a “consumer” under the Magnuson-Moss Warranty Act, or applicable state laws, then you may be entitled to any implied warranties allowed by law for the Warranty Period. Further, some states do not allow limitations on how long an implied warranty lasts or allow the exclusion or limitation of consequential damages, so such limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

For the name of your nearest authorized NILES dealer, contact: NILES AUDIO CORPORATION, P.O. BOX 160818, Miami, Florida 33116-0818, or call 1-800-289-4434, 1-

305-238-4373. Please be advised that NILES only sells its products via the Internet through a select group of authorized Internet dealers. These are listed on our website at www. nilesaudio.com. Products offered on the Internet through unauthorized Internet dealers are not covered by the NILES warranty and may be either:

1)goods acquired on a secondary or grey market

2)counterfeit or stolen goods

3)damaged, or defective goods

ATTENTION: TO OUR VALUED CONSUMERS:

To insure that consumers obtain quality pre-sale and after-sale support and service, NILES products are sold exclusively

I N S T A L L A T I O N & O P E R A T I O N G U I D E

hand-held learning remote control

©2008 Niles Audio Corporation. All rights reserved. Niles, the Niles logos, MicroFlashers and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation. All other trademarks are the property of their respective owners. DS00622A

to save all data learned.

11

programming mode

12

13 14

remote control

15

16

This warranty does not cover reimbursement for your costs of removing and transporting the product for warranty service evaluation, or installation of any replacement product provided under this warranty.

17

through authorized dealers. This warranty is VOID if the products have been purchased from an unauthorized dealer.

18

R-6L R-8L