Niles Audio SI-245 manual Installation, Setting the Turn-OnMode Switch, Control Output

INSTALLATION

INSTALLATION

9	Setting The Turn-On Mode Switch	13	Cascade Audio Outputs
9	Control Output	14	AC Power plug
10	Speaker Wire Connections	17	Rail Fuse Holders
13	Line Level Audio Inputs

Setting the Turn-On Mode Switch

The SI-245 has three turn-on modes. Select the mode you wish to use by sliding the mode switch. See Installation Considerations on page 6 for more information about each of the turn-on modes.

Slide the switch with your fingernail or a 1/8” slotted screwdriver blade.

Control Output

This terminal provides a 12v DC signal suit- able for triggering Niles automated switchers, some motorized screens, some electric curtain controls, etc. The trigger voltage is present only when the amplifier is active or "on". When the amplifier turns "off", the 12 volt sig- nal is off.

Using the 3.5 mm jack.

STEP	DESCRIPTION
1. Check the requirements of the	The control output has a maximum
device you want to control.	current capability of 12vDC 150 mA.
2. Connect the 3.5mm Jack to the	Niles makes an accessory cable
control output maintaining proper	plug FG00724.
polarity (tip = +)

11