Niles Audio SVL-4AB manual Operation, Playing One Pair of Speakers At a Time

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

"TECH TIP"

If your amplifier or

receiver has "A" and "B" speaker- pair outputs, connect the SVL-4AB to the "A" outputs. Do not connect anything to "B". This will prevent the amplifier or receiver from driving an unusually low impedance load.

Operation

The are two ways to use the SVL-4AB. You may play and adjust the volume of one pair of speakers at a time, or play multiple pairs simultaneously.

If you intend to play more than one pair of speakers at the same time, you will need to become familiar with the opera- tion of the SVL-4AB's PROTECTION button.

Playing One Pair of Speakers At a Time

1.Make sure the amplifier or receiver power is OFF and set the volume to minimum.

2.Set the SVL-4AB volume control for the speaker pair you wish to play to maximum (fully clockwise).

3.Locate the ON/OFF button on the SVL-4AB which corre- sponds to the speaker pair you wish to play. Set it to the ON position.

4.Adjacent to the ON/OFF button is the amplifier A/B but- ton. Choose an amplifier for the active speaker pair by press- ing the A/B button in for “B” and out for “A”.

5.Turn on the amplifier or receiver and select a source, such as the tuner or CD player.

6.Slowly turn up the amplifier or receiver volume and set it to a comfortable (not maximum) listening level. Be careful

11