S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M
Installation Considerations
SVL-4AB Power Handling
The SVL-4AB is designed for use with receivers or amplifiers having a maximum power output of 100 watts per channel at 8 ohms. Damage caused by the use of higher-power receivers or amplifiers will void the warranty. Consult your Niles dealer or receiver/amplifier manufacturer if you are uncertain about the power rating of your receivers or amplifiers.
IMPORTANT: DO NOT USE THE SVL-4AB WITH AMPS OR RECEIVERS RATED AT MORE THAN 100 WATTS PER CHANNEL RMS AT 8 OHMS.
Amplifier Impedance Load
As more pairs of speakers are parallel connected to a receiver or amplifier, the overall system impedance becomes lower. For example, if two pairs of 8-ohm speakers are connected in parallel, the impedance will be 4 ohms; two pairs of 4-ohm speakers in parallel become 2 ohms, and so on.
Most receivers or amplifiers are not rated for use below a 4 ohm load. Most manufacturers do not recommend connecting more than two pairs of speakers without using some form of impedance correction.
TOOLS
REQUIRED
•1/8" Standard Slotted Screwdriver
•Wire Stripper
IMPORTANT
DO NOT use the SVL-4AB with amps or receivers rated at more than 100 watts per channel RMS at 8 ohms.
