2.(Auto) POWER Switch: Use the ALWAYS ON mode to leave the SW10 and SW12 always on. Use the MUSIC/VOLTAGE SENSE mode to automatically power on the SW10 and SW12 when audio signals are present or when system trigger is used. When signals are absent, the SW10 and SW12 will enter the standby mode.
NOTE: THE ALWAYS ON AND MUSIC/VOLTAGE SENSE SETTINGS ARE ONLY ACTIVE AFTER (MASTER) POWER IS SET TO ON (SEE BELOW).
3.AUDIO IN jacks: Use these gold-plated, line-level RCA input jacks to connect line-level stereo or LFE audio signals from a home theater surround sound processor or receiver. The LFE (Low Frequency Effects) input is not affected by the LOW PASS Frequency Control. The PHASE Control and LEVEL Control continue to function as normally expected.
4.AUDIO OUT jacks: Use these gold-plated, line-level RCA output jacks to connect line-level stereo or LFE audio signals to drive another SW10 or SW12. The L/R output signals are routed through a fixed HIGH-PASS (80 Hz) filter.
5.SPEAKER IN Binding Posts: As an alternative to the AUDIO IN jacks, use the loudspeaker-level, gold-plated, five-way binding posts to connect loudspeaker-level, stereo audio signals from a home theater surround sound processor or receiver. For additional connection details, see FINISHING THE INSTALLATION on page 13.
6.SPEAKER OUT Binding Posts: As an alternative to the AUDIO OUT jacks, use the loudspeaker-level, gold-plated, five-way binding posts to connect loudspeaker-level, stereo audio signals to drive your front L/R satellite loudspeakers.
7.(Master) POWER Switch: Use this control to power on/off the SW10 and SW12.
8.Detachable IEC Power Cord and built-in fuse. If needed, replace the fuse with same type, as follows:
•For 115/120 Vac @ 60 Hz, use a T5AL, 250V fast-blow fuse.
•For 230/240 Vac @ 50 Hz, use a T3.15AL, 250V fast-blow fuse.
