Niles Audio VCS-2D-HP manual Operation

H I G H P O W E R S T E R E O V O L U M E C O N T R O L

Operation

1.Make sure the amplifier or receiver power is OFF and set the volume to minimum.

2.Set the VCS-2D-HP volume to maximum (fully clockwise).

3.If you are using a Niles speaker selection system, locate the ON/OFF button which corresponds to the speaker pair you wish to play. Set it to the ON position.

4.Turn on the amplifier or receiver and select a source, such as the tuner or CD player.

5.Slowly turn up the amplifier or receiver volume and set it to a comfortable (not maximum) listening level. Be careful not to overdrive or "clip" your amplifier. If the sound becomes muddy or distorted, you have reached the limit of your amplifier’s volume capability and should quickly reduce the volume to avoid damaging your speakers.

6.Adjust the volume of the speakers to the desired listening level using the VCS-2D-HP. If all the speaker pairs in your system are equipped with Niles volume controls, you can leave the amplifier or receiver volume set at one position and use the Niles controls exclusively.

7.You can turn off the speakers by turning the knob on the VCS-2D-HP fully counter-clockwise, or by pressing the ON/OFF button on your speaker selector.

SPECIFICATIONS

Audio Power

Handling

200Watts/channel peak music power

100Watts/channel continuous power

Mounting In-wall, fits into most 18 cu. inch single- gang electrical boxes at least 2 3/4” deep, Decora-style faceplate

Wiring Requirements Individual runs of

2-conductor speaker wire, 14-22 gauge

Unit Dimensions

1 5/8" wide x 2 5/8" high

Face Plate Dimensions

Decora wall plate;

2 3/4” wide x 4 1/2” high

Depth Behind Plate

29/16”

10