![](/images/new-backgrounds/1029638/29638109x1.webp)
PROGRAMMING OVERVIEW
PROGRAMMING A LEARNING REMOTE FOR ZONE OPERATION
Learning remote controls can be taught the IR commands of the Niles
Important Note: IR Sensors cannot operate a zone when used alone. They must be installed and connected to a Solo™ Master Keypad Module.
The commands you will teach from the Niles
1.Source buttons Tuner, 2, 3, and 4. These acti- vate the system, turn the zones on, and select the desired source. The Tuner button always selects the
2.Function buttons to issue the IR commands for each of the individual source components.
3.Volume and mute buttons to control the vol- ume in a zone.
4.The Off button to turn off the zones.
To teach these commands, simply take the learn- ing remote that you will be using in the zone, set it to the learning mode, choose the appropriate key on the learning remote, and then issue the appropriate command from the Niles
To test the commands, set the Niles remote aside, take your learning remote, and try the commands. If they were captured correctly, you will be operat- ing the system and all the source components iden- tically to the Niles
Learning
Remote Control
Niles
R-4 Remote
Figure 47
PROGRAMMING A HOME THEATER REMOTE CONTROL TO OPERATE SOURCE COMPONENTS SHARED WITH A
A learning remote control operating a home theater system can be programmed to operate source compo- nents shared with the
The learning remote control may be programmed with the source component's factory IR commands using the
55