Nilfisk-Advance America 15S, 12D Changing The Exhaust Filter, Cleaning Or Changing The Pre Filter

CHANGING THE EXHAUST FILTER

1.Disconnect the power cord from the electrical outlet.

Push the Filter Cover Latch (19) downwards so that the Filter Cover (18) is released.

2.Remove the cover with the filter, from the cleaner.

3.Remove the used and dirty exhaust filter.

4.Insert a new exhaust filter to the filter cover.

5.Snap the Filter Cover back in place on the cleaner.

IMPORTANT !

Never operate the machine without the Exhaust Filter in place at the machine.

1

2

CLEANING OR CHANGING THE PRE FILTER

The pre filter catches any dirt spilled from the bag, before it can enter the vacuum motor. The filter is located below the bag.

Clean the filter every third time that the bag is changed (more often in very dusty applications).

To clean/replace the Pre Filter.

1.Disconnect the power cord from the electrical outlet. Then push the Dust lid button (16) in and remove the dust lid (5).

2Grasp at the filter holder and pull the holder out from the Dust compartment.

3.Remove the dirty filter from the filter holder and replace with a new pre filter. The pre filter may also be washed. Wash it in warm

water. Let the filter dry completely before putting it back into the
	1
filter holder.

4.This machine is also equipped with a deodorizer pad. It´s located in the pre filter holder.

Replace it to a new deodorizer pad when the function begins to fade.

5.Put back the new/washed filter into the holder. Then put back the holder with filter in place in the bag housing.

6.Fit the two notches of the back cover to the two slots at the lower part of the bag housing, and push the back cover back in place at the housing.

IMPORTANT !

Never operate the machine without the pre-filter in place.

3

2

5

AFTER USING THE MACHINE

1.Unplug the Power Cord from the electrical outlet.

2.If the machine is not cleaning as expected and the “Restricted Airflow light” is not illuminated, open the dust housing to en- sure that the dust bag is not full, replace it if necessary. See also separate instructions for replacing the dust bag. Clean the bag housing if necessary.

3.Wind up the cord (starting from the machine inlet side).

4.Store the cord on the hook at the Dust lid cover and the hook at the handle.

5.Check the brush house. Remove any built-up carpet fibers or debris from the brush and the brush housing.

6.Store the machine indoors in a clean, dry place.

3 4

13