36
7 Filter and dust bags - Centix 40 / Centix 50 Premium 7.3 Replacing the dust bag
The machine is supplied with a paper dust bag.
Replace the dust bag in the following way:
1. Pull the inlet socket out of the machine.
2. Release the two handles clamped on to the dust
container. Free them by pulling the handles outwards
away from the container.
3. Lift off the container.
4. Shake the dust from the bag fi lter. It may be
advantageous for the fi lter to be installed in the
container in such a way that dust in the fi lter can be
shaken down into the dust container.
5. Lift out the bag fi lter.
6. Remove the dust bag by taking hold of the cardboard
stiffener and carefully pulling out the card and bag
from the container, Fig. 23.
7. Empty the container of dust.
7.1 Replacing the bag fi lter
A bag fi lter must always be installed in the dust container.
Clean the fi lter in the following way:
1. Start by pulling the pipe socket out of the dust
container.
2. Release the two handles clamping the dust container.
Free them by pulling the handles outwards away from
the container, Fig 20.
3. Do not remove the fi lter from the container. Instead,
give the fi lter a light shaking inside the container to
loosen dust from the fi lter allowing it to fall into the
container, Fig. 21.
4. Lift out the bag fi lter. If a dust bag is being used -
remove the dust bag. Then empty the container of any
remaining dust in a suitable place.
7.2 Fitting the bag fi lter
Replace the bag fi lter in the machine as follows:
1. Replace the cleaned/shaken bag fi lter in the
container, Fig. 22. Make sure the fi lter support fi ts into
the inner edge of the dust container properly. Check
that the fi lter is fi tted the right way up - the cloth
handle on the fi lter should be visible.
2. Then replace the dust container with the bag fi lter in
the cleaner’s vacuum unit.
3. Close the container on the vacuum unit by applying
inward pressure to the two handles to ensure the
vacuum unit and dust container are fi tted together
properly.
4. Fit the inlet socket to the machine.
7.4 Fitting the dust bag
Replace the dust bag as follows:
1. Fit the dust bag’s card with a hole into the bag holder,
Fig. 24.
2. Replace the cleaned/shaken bag fi lter in the
container. Make sure the fi lter support fi ts into the
inner edge of the dust container properly.
Check that the fi lter is fi tted the right way up - the
cloth handle on the fi lter should be visible, Fig. 22.
3. Replace the dust container on the vacuum unit. Close
the container on the vacuum unit by applying inward
pressure to the two handles to ensure the vacuum unit
and dust container are fi tted together properly.
4. Replace the inlet socket in the machine.
Fig. 20 Fig. 21 Fig. 22
Fig. 23 Fig. 24