Nilfisk-ALTO 571, 586 manual How To Operate the Machine

How To Operate the Machine

How to Operate the Forward / Reverse Switch (see figure 28).

1.To go forward, push the up arrow side of the switch.

2.To go in reverse, push the down arrow side of the switch.

How to Fill the Solution Tank

The solution tank fill port is located at the left side of the machine (see figure

29). To fill the solution tank, follow this procedure:

1.Turn the key switch to the “OFF” position.

2.Remove lid.

3.Add a cleaning chemical to the solution tank. For the correct amount of chemical, follow the directions shown on the container. NOTE:

Excess foam in the recovery tank could damage the vacuum motor, so use only the minimum amount of detergent necessary.

WARNING: Always use low foam detergent. To avoid the production of foam, before starting to clean, put a minimum quantity of antifoam liquid into the recov- ery tank. NEVER USE PURE ACID.

4.Fill the solution tank with clean water (see figure 29).

5.After filling the solution tank, replace the solution tank lid.

WARNING: Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surface. These areas can cause a dangerous condi- tion for the operator or other persons. Always put CAUTION signs near the area you are cleaning.

WARNING: Machines can ignite flammable materials and vapors. Do not use with or near flammables such as gasoline, grain dust, solvents and thinners. Only use a cleaning concentration recommended by the chemical manufacturer.

WARNING: Nilfisk ALTO recommends a maximum water tem- perature of 120°F (49°C).

Operating the Machine

NOTE: Before scrubbing with the machine, become familiar with the opera- tions and handling of the machine. Run the machine at the lowest traverse speed. Use the machine in an area that has no furniture or objects until you can do the following:

1.Traverse the machine in a straight direction, forward and backward.

2.Stop the machine safely.

3.Turn the machine both left and right and return to a straight direction.

4.Turn a 180o turn where one rear wheel just pivots.

Figure 28

Figure 29

Nilfisk ALTO Operator’s Manual - SCRUBTEC R Manual Steering Form No. 71274A Page -19-