Put the charger on a flat surface. Make sure the vents on the sides of the charger are at least two inches away from the walls and other objects. Make sure there are no objects near the bottom vents of the charger.
To charge the batteries, follow this procedure:
1.Turn the machine OFF.
2.Connect the DC connector on the charger to the connecting plug on the side of the machine above the circuit breaker.
3.Connect the AC plug on the charger to a receptacle that has the correct voltage and frequency for your charger. Make sure the receptacle is connected to the electrical ground.
NOTE: Read the DC ammeter on the charger. These conditions are normal:
-In the "Start" position, the ammeter dial is in the white area of the meter.
-In the "Finish" position, the ammeter is in the green area of the meter.
If the conditions are not normal, unplug the charger from the wall.
7.The electronic timer stops the charger when the batteries are fully charged.
See the instruction book for the charger, and for more instructions on how to use the charger and charge the batteries.
Clarke® Model 590/590B Operator's Manual | Page 7 |