HOWTOADJUSTTHEBRUSH
The brush height adjustment has four settings. To adjust the setting, pull out the handle on the
For very low pile carpet, and for hard surface floors, put the adjustment lever in the farthest forward position.
HOWTOOPERATETHEMACHINE
Use the Models 590/590B Space Vac only on large areas of floor. Move the machine steadily forward and backward in short movements.
To clean near the wall, put the guide wheel on the
Stop when the performance of the machine decreases.
SERVICE
The following should be done by the operator when servicing the machine:
Keep the machine clean. It will have longer life and need fewer repairs.
For the best performance, remove the contents of the filter bag each time you finish using the machine. Sweep the inner surface of the bag for the best filter efficiency.
STORAGEOFTHEMACHINE
Before you put the machine in storage, clean the machine and the filter bag. Put the power cord around the top of the handle. To put the handle in the storage position, pull out the two knobs on the handle. Rotate the knobs ¼ turn. Put the handle forward into the storage position. Keep the machine in a storage area in a building.
CIRCUITBREAKER
The electrical circuit in the Model 590 is protected by a circuit breaker. If the circuit breaker opens, wait approximately 10 minutes for the machine to cool. Press the red button on the
Check the vacuum system and the brush for obstructions. Check the settings of the brush. Obstructions or an incorrect brush setting can make the motor too hot.
Brush Height Adjustment - Figure 3
WRONGCORRECT
Figure 4
Figure 5
Clarke® Model 590/590B Operator's Manual | Page 9 |