Nilfisk-ALTO 653E Use, Before Machine START-UP, Brush/pad-holder installation/removal, Mm-models

ENGLISH USER MANUAL

USE

WARNING!

On some points of the machine there are some adhesive plates indicating:

– DANGER

–WARNING

–CAUTION

–CONSULTATION

While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if damaged.

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal

1.Place the brush (A, Fig. 1) or the pad-holder (B) under the deck (14).

2.Lower the deck on the brush/pad-holder by pressing the pedal (8).

3.Connect the power supply cable (3) to the electrical mains.

4.Engage the brush or pad-holder by pressing the switch (51) for a few seconds.

5.Press one of the switches (55) to engage the brush or the pad-holder.

WARNING!

Do not press the switches (55) too much, otherwise the machine will start.

6.To remove the brush/pad-holder lift the deck by pressing the pedal (8), then manually remove the brush/pad-holder from the hub, by turning it in the opposite direction to the normal rotation direction.

S311334

Figure 1

Types of brushes available

530mm-models

PROLENE MIDLITE GRIT 180 MIDGRIT 240 PROLITE UNION MIX

10

SCRUBTEC 653E 9097060000(2)2009-10 A