ENGLISH USER MANUAL
TROUBLESHOOTING
Trouble | Possible Cause | Remedy | |
|
|
| |
The motors do not operate. | The power supply cable or the relevant plug | Replace the cable. | |
is broken. | |||
|
| ||
|
|
| |
| The recovery tank is full. | Empty the tank. | |
|
|
| |
| The hose is disconnected from the squeegee. | Connect. | |
|
|
| |
| The vacuum grid is clogged or the float is | Clean the grid or check the float. | |
The recovery water vacuuming is insufficient. | stuck closed. | ||
| |||
|
| ||
| The squeegee is dirty or the squeegee blades | Clean and check the squeegee. | |
| are worn or damaged. |
| |
| The tank cover is not properly closed or the | Close the cover or clean/replace the gasket. | |
| gasket is damaged. | ||
|
| ||
|
|
| |
The solution flow to the brushes is insufficient. | The solution filter is dirty. | Clean the filter. | |
|
| ||
The tank is dirty (the drain hole is clogged). | Clean the tank. | ||
| |||
|
|
| |
| There are debris under the squeegee blades. | Remove the debris. | |
|
|
| |
| The squeegee blades are worn, chipped or | Replace the blades. | |
The squeegee leaves marks on the floor. | torn. | ||
| |||
|
|
| |
| The squeegee has not been adjusted with the | Adjust it. | |
| handwheel. |
|
For further information refer to the Service Manual, available at any Nilfisk Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law in force:
–Brushes/pads
–Plastic hoses and components
–Electrical and electronic components (*)
(*)Refer to the nearest Nilfisk Alto Center especially when scrapping electrical and electronic components.
18
SCRUBTEC 653E |
