ENGLISH USER MANUAL

10 FLOORTEC R 580 B 146 2601 000(1)2005-03 A

7. Press both the enabling switch (1, Fig. B) and the
hopper lowering switch (15) to lower the hopper down
to the desired position.
8. The machine is ready to start working again.

AFTER USING THE MACHINE

After working, before leaving the machine:
– Lift the main broom with the lever (24, Fig. B).
– Lift the side brooms with the levers (21 and 22, Fig.
B).
– Close the suction by means of the related lever (17,
Fig. B), then press the filter-shaker switch (14, Fig. B)
for a short interval; open the suction again.
– Dump the hopper (4, Fig. C) (see previous
paragraph).
– Remove the ignition key from the switch (18, Fig. B).
– Engage the parking brake by pressing the brake
pedal (26, Fig. B), then activate the brake lock control
lever (19).

WORKING LIGHT ADJUSTMENT

If necessary, adjust the working light (9, Fig. C) beam
aiming with the screws (22).

MACHINE LONG INACTIVITY

If you foresee that the machine will not be used for more
than 30 days, proceed as follows:
– Check that the machine storage area is dry and
clean.
– Disconnect the battery connector (4, Fig. V).

FIRST PERIOD OF USE

After the first period of use (first 8 hours) it is necessary to
check that the fixing and connecting elements are
correctly tightened, that the visible parts are integral and
that there are no leakages.
MAINTENANCE
The lifespan of the machine and its maximum operating
safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance.
The intervals shown may vary according to particular
working conditions, which are to be defined by the person
in charge of the maintenance.
All scheduled or extraordinary maintenance operations
must be performed by qualified personnel, or by an
authorised Service Center.
This manual describes only the easier and most common
maintenance procedures.
WARNING!
The hopper can be overturned only if it is
not in its original position (horizontal
position).
WARNING!
Operations to be carried out with the
machine off, the ignition key not inserted
and (if required) the battery disconnected.
Moreover, carefully read the instructions in
the Safety chapter.
NOTE
For other maintenance procedures contained
in the Scheduled Maintenance Table or for
extraordinary maintenance operations see the
specific Service Manual that can be consulted
at any Service Center.