MAINTENANCE (CONT.)
9.Place the rubber end cap covers over both end caps (flat side against end cap). Align holes and secure. Then, slant the brush roll forward so the end caps are in line with the slots in the cleaner base. Push the brush roll into the base until seated. See figure 6.
10.Place the lower side of the belt into the belt guide and around the left side of the motor pulley. See figure 7.
CAUTION: Improper installation of the brush roll or brush roll belt could cause carpet or cleaner damage.
11.To install the chrome bottom plate, put the tab on the base in the slot in the plate. Press the center of the plate against the base of the machine. Turn the cam latches to fasten the plate to the base.
See figure 8.
What to Do About the Wear of the Brush
1.Make sure the electrical plug is removed from the electrical outlet.
2.Put the machine upside down.
3.To remove the bottom plate, turn the two cam latches on the sides of the plate.
Figure 6
Figure 7
Cam Latch
Tab
Figure 8
CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual | Page |
