MAINTENANCE
This section describes the procedures that must be done by the operator.
WARNING: To prevent injury, always turn off the switch and remove the electrical plug from the electrical outlet before changing the brush, belt, or filter bag and before leaving the machine.
WARNING: To prevent electrical shock, always turn off the switch and remove the electrical plug from the electrical outlet before doing any repairs or maintenance to this machine.
WARNING: Belt pulleys can become hot during normal use. To prevent burns, do not touch the belt pulley when servicing the drive belt.
WARNING: Maintenance and repairs must be done by authorized personnel only.
The Belt to Drive the Brush
This machine uses a round rubber belt to drive the brush. Check the belt frequently. Replace the belt if the belt slips on the brush. Remove hair and threads from the brush roll and the motor shaft pulley before replacing the belt.
How to Replace the Belt
To replace the drive belt, follow this procedure:
1.Make sure the electrical plug is removed from the outlet.
2.Put the machine upside down.
3.To remove the bottom plate, turn the two cam latches on the sides of the plate.
4.Remove the worn belt from the pulley on the motor shaft. See figure 4.
5.To remove the brush, pull the brush out of the slots in the frame.
6.Clean the vacuum opening in the base of the machine.
7.Check the bristles of the brush for wear. If the bristles are worn, see the section "What to Do about the Wear of the Brush."
8.Put a new belt around the pulley on the brush. Align the brush roll pulley with the belt guide. See figure 5.
Motor Pulley
Figure 4
Belt
Guide
Figure 5
Page | CLARKE TECHNOLOGY Symphony Upright Vacuum Operator's Manual |
