Nilfisk-ALTO TB50 MOTOR WILL NOT START, CUTTING ATTACHMENT WILL NOT ADVANCE LINE, CUTTING LINE ADVANCES UNCONTROLLABLY, SPECIFICATIONS, TROUBLESHOOTING, MOTOR, C A U SE

	TROUBLESHOOTING
MOTOR WILL NOT START
C A U S E	A C T I O N
Unit is unplugged	Check cord to make sure it is still plugged into an electrical outlet
Overload protection switch has popped	Reset overload protection switch
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
C A U S E	A C T I O N
Cutting attachment bound with grass	Stop the unit and clean cutting attachment
Cutting attachment out of line	Refill with new line
Inner reel bound up	Replace the inner reel
Cutting head dirty	Clean inner reel and outer spool
Line welded	Disassemble, remove the welded section and rewind
Line twisted when refilled	Disassemble and rewind the line
Not enough line is exposed	Push the bump knob and pull out line until 4 inches (102 mm) of line
	is outside of the cutting attachment
CUTTING LINE ADVANCES UNCONTROLLABLY
C A U SE	A C T I O N
Oil, cleaner or lubricant in cutting head	Clean and thoroughly dry the cutting head

If further assistance is required, contact your authorized service dealer.

SPECIFICATIONS
MOTOR
Motor type...........................................................................................................................................	A.C.,120 Volts Electric
Operating RPM.............................................................................................................................................	up to 7,400 rpm
On/Off Switch .............................................................................................................................................................	Trigger
Amperage................................................................................................................................................................	4.7 amps
DRIVE SHAFT AND CUTTING HEAD
Drive Shaft Housing ..............................................................................................................................................	Steel Tube
Unit Weight (With cutting attachment, cutting attachment shield and D-handle) .............................................	9 lbs. (4.1 kg)
Cutting Mechanism .......................................................................................................................................	Bump Head™
Line Spool Diameter .................................................................................................................................	3 inches (76.2 mm)
Trimming Line Diameter ...........................................................................................................................	0.065 in (1.65 mm)
Cutting Path Diameter....................................................................................................................................	15 in (381 mm)

13